用途:
用于非吸收性、密实或光滑表面基层的界面处理。
特点:
绿色环保;
粘接桥作用,增强界面附着力;
经济实用,涂布面积大。
适用基层:
适用于非吸收性基层如石材、水磨石、瓷砖、轧光混凝土、沥青和木板表面;可用于最高温度为50℃的地暖或地热基层上。但是对于多尘、易脆表面、金属木屑板、氧化镁、硫酸钙基层,本产品不宜使用,同时本产品不能作为防潮层使用。本产品仅在室内使用。
基层处理:
基层应坚实、平整、干燥、清洁、无裂缝、无油脂、无脱膜剂等化学助剂。如基层表面光滑,需打磨拉毛处理;含水率高的基层需做专业防潮处理。
施工方法:
M320非吸收性界面处理剂无需兑水,即开即用。使用前,均匀摇动容器,然后开启使用。注意不要将产品直接倾倒基层之上,应将其先倒入滚筒托盘中,再用羊毛滚筒均匀、薄薄地涂刷整个基层,一定要避免积液。待M320彻底干透后方可进行下一步施工。
注意事项:
本产品最佳施工环境为温度15℃以上及相对湿度75%以下。应确保施工现场通风良好。
包装与储存:
20kg塑料桶包装。本品须存放于5℃-35℃室内,防止冰冻、曝晒。保质期12个月。
技术参数:
M320 Non-absorbent Primer
Uses:
For interface treatment of non-absorbable, dense or smooth surface base.
Features:
Green and environmental protection;
Bonding bridge effect, enhance interface adhesion;
Economical and practical, large coating area.
Applicable Subfloor :
Suitable for non-absorbent base such as stone,terrazzo,ceramic tile,calendered concrete, asphalt and wood surface. It can be used for floor heating or geothermal base with the highest temperature of 50℃. But for dusty, brittle surface, metal wood chip board, magnesium oxide, calcium sulfate base, this product is not suitable for use, at the same time, this product can not be used as a moisture-proof layer. This product is for indoor use only.
Primary Treatment:
The base should be solid, smooth, dry, clean, no cracks, no grease, no film removal agent and other chemical additives. Such as smooth surface of the base, need to polish hair processing; High moisture content of the grassroots need to do professional moistureproof treatment.
Construction Method:
M320 non-absorbable primer does not need to be added with water and is ready to use. Before use, shake the container evenly and then open it for use. Do not dump the product directly on the base, it should be poured into the drum tray, and then use the wool drum evenly and thinly coated the whole base, must avoid liquid accumulation. Proceed to the next step after the M320 is completely dried.
Note:
The best construction environment for this product is temperature above 15℃ and relative humidity below 75%. Ensure that the construction site is well ventilated.
Packaging and Storage:
20kg plastic pails. The product shall be kept at room 5 ℃ -35 ℃, prevent freezing, exposure. Shelf life is 12 months.
Technical Parameters: